SimScale simulation projects by mnoor_mohamed | Page 1

mnoor_mohamed's profile

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

In this exercise, we will consider the deflection of a cantilever beam with a concentrated load at the free end. We can calculate the deflection by hand and via a static analysis using the SimScale platform.

Turbine type  Archimedes Screw
1 (No of helix)
No of blades 20
Head 1 m
Optimum angle 18 degree  referred from journal in internet
Length of the turbine shaft 3000
Geometry Details(dimension in mm)
Flow domain is cylinder dia (1200) length (3600)
MRF Volume cylinder dia(1100)  length(3400)
Turbine OUTER dia (1000) INNER dia(shaft dia) (400)
Total shaft length (3200)

Updated geometries for the section Incompressible Fluid Flow analysis of two globe valves of the Introduction to Computer-Aided Engineering (CAE) course - www.simscale-academy.com

The effect of numerics on the simulation quality and convergence time.

In this exercise, you will complete a laminar pipe flow analysis

In this exercise, you will perform a simple heat transfer analysis on the SimScale Platform and then compare the results to a hand-calculated solution.

In this exercise, you will use linear static analysis to analyze several configurations of an aircraft engine bracket under a vertical load.

Learning Incompressible flow for screw turbine with small model

This  project analyzes the aerodynamics of a spoiler

Public Profile

mnoor_mohamed's profile